Subject: RE: Ramsey SCA Kit and pro-2004

From: [email-masked] (David L. Wilson)
Date: 17 May 93 23:27:32 GMT

The proper place to tap the PRO-2004 for SCA happens to be test point TP3
which is near the center of the main (LINEAR) PC board.

On the PRO-2005/6, it is test point TP1  which is under the smaller
covered enclosure parallel to connector CN1.  (The 2004 test point is
not under a cover however.).

In both cases, tape the test point via a low (.01 uf will do) capacitor
but I suspect the Ramsey unit already has one.

Not sure about Canadian law but in the US, non-authorized SCA listening
is explicitly forbidden by the ECPA.
--
David L. Wilson                  INTERNET:  [email-masked]
Phone: (703) 898-1084 (H)        Amateur callsign:  AC4IU